TBC thermal barrier coating for engine and exhaust parts
In motorsport, tuning and aviation, TBC stands for thermal barrier coating. It is a high-tech ceramic coating applied to parts exposed to extreme heat.
Priced per part. Send photos and you get a price before you ship anything.
Where it is used
On exhaust manifolds, turbine housings, piston crowns and throughout the exhaust system.
How it works
A special ceramic composition, often based on zirconium oxide, acts as a strong heat insulator and stops the metal surface from soaking up heat. The heat stays in the exhaust gas instead of being absorbed by the metal of the exhaust system, which raises the gas flow speed and engine power.
At about 0.3 mm thick, the coated surface runs about 25–33% cooler than the same part uncoated.
Heat management in motorsport
In motorsport, thermal conductivity and its control, known as thermal management, are decisive. Race cars run at extremes, with temperatures in the engine and exhaust system from 800 °C to more than 1000 °C.
What the coating does
- Protects metal parts from overheating and weld seams from cracking
- On naturally aspirated engines, a steady exhaust gas speed, because the heat stays in the gas instead of the metal
- Lower coolant and engine oil temperatures, as the coated exhaust helps carry heat away from the engine
- Better power curves, an engine that revs higher, and quicker, easier tuning on the dyno
- Better acceleration, and an exhaust that reaches working temperature sooner
Questions
Is a thermal barrier coating the same as a ceramic exhaust coating?
For exhaust parts, yes: "ceramic coating" usually means a thermal barrier coating. The difference is that it uses specially developed and manufactured ceramic oxides, which stay stable through heat-driven phase changes. We use thermal spraying, which builds a thicker and more porous ceramic layer than paint-on products: the surface first gets a nickel-chrome (NiCr) bond layer, then the ceramic powder is sprayed on top.
How much cooler will my part run?
Typically the surface temperature is about 25–33% lower at 0.3 mm coating thickness. The exact result depends on the part, its material, the ceramic oxide and the engine load.
Sending a part by courier
Most parts reach us by courier. It takes three steps.
Send photos and details
Use the form or WhatsApp. Tell us the part, the car or engine, and anything we should know, such as cracks or earlier repairs.
Pack and ship the part
Once you accept the quote, remove sensors, gaskets and heat shields, pack the part well and ship it with any courier.
Get it back coated
We coat the part and send it back to you, or you pick it up in Riga.
Shipping address
We send the shipping address together with your quote.
Packing tips
- Wrap flanges and threads so they cannot be damaged in transit.
- Use a sturdy box and fill the empty space so the part cannot move.
- Put a note inside with your name, phone number and what you want coated.
Parts we coat for this
Exhaust manifold
Cast manifolds and tubular headers: the hottest part of the exhaust and the best place to start.
Turbo housing
The turbine housing is a heat source right next to your intake. Coating it cuts heat soak.
Downpipe
The pipe right after the turbo, often routed past the gearbox, driveshaft and floor.
Intake manifold
Keeps engine heat out of the intake air on its way to the cylinders.
Pistons
A ceramic layer on the crown limits how much combustion heat soaks into the piston.
Brake pads and shims
A heat barrier between the pad and the caliper that keeps brake fluid cooler.
Motorcycle exhaust
Headers and collectors that run close to your legs, the frame and the fairings.
Get a quote for your part
Tell us what you want coated and add a few photos. We reply with a price and a timeline.